Products A-Len

A-Len masterbatches are  intended for adding to polypropylene and polyethylene in ratio 1 – 50% depending on your technology  and requirements to final product. At processing of polypropylene A-Len prevents fibrillation of flatyarn at extrusion, decrease shrinkage at injection moulding. At processing of polyethylene A-Len improves printability of product’s surface, stabilizes the bubble at blowing and saves the cost of ready products.

A-Len masterbatches are  intended for adding to polypropylene and polyethylene in ratio 1 – 50% depending on your technology  and requirements to final product. At processing of polypropylene A-Len prevents fibrillation of flatyarn at extrusion, decrease shrinkage at injection moulding. At processing of polyethylene A-Len improves printability of product’s surface, stabilizes the bubble at blowing and saves the cost of ready products. A-Len is beautiful decision for cost saving without loss of quality.

Used the above table you are able to select the grade of A-Len which can be best optimal exactly for your application type. At that it is necessary to keep in mind that final decision about using concrete grade in your production should be made only after its test run on your production line. Please contact our specialists to receive test samples and they will provide you will necessary advice.

Recommendation for using of additives in the above table have been elaborated based on experience of their actual using and actual for most cases. Nevertheless they are for your reference only. Result of application of filler depends on screw design, type and grade of processed material, kinds and quality of other used additives (color, stabilizer, etc.), requirements to the final product. According to the mentioned factors the fillers can proceed differently in concrete case.